VTX2 ver 8.0.1.RC
INAV 9.0.2
F'C SBF7v3 9.0.1. (Latest)
I can't confirm that the switching works between cam1 and cam2. (BTW cam 1 and cam 2 maybe mislabeled on the board)
I can confirm that the analog camera works on board with jumper one and two bridged.
However, confirming by the LEDs on board, the adapter only switches between cam one and cam 2. When switched to cam 3, cam one is still active (as confirmed by the LED, as well as visually in goggles)
I can also confirm that INAV cam1, cam2, cam3, modes are set correctly.
I realize we are on RC with 8.0.1. no 7.0.1 is available as is recommended
No documentation is available for this device other than the descriptions on the sales page, as well as descriptions on back of adapter.
Seriously, am I the first one to use this?
Please advise.
VTX2 ver 8.0.1.RC
INAV 9.0.2
F'C SBF7v3 9.0.1. (Latest)
I can't confirm that the switching works between cam1 and cam2. (BTW cam 1 and cam 2 maybe mislabeled on the board)
I can confirm that the analog camera works on board with jumper one and two bridged.
However, confirming by the LEDs on board, the adapter only switches between cam one and cam 2. When switched to cam 3, cam one is still active (as confirmed by the LED, as well as visually in goggles)
I can also confirm that INAV cam1, cam2, cam3, modes are set correctly.
I realize we are on RC with 8.0.1. no 7.0.1 is available as is recommended
No documentation is available for this device other than the descriptions on the sales page, as well as descriptions on back of adapter.
Seriously, am I the first one to use this?
Please advise.