DATV

[magnum88]

Hi all
i check for my ZynqSDR
a possible for make run on QO100 by DATV
i seek rtmp or udp
but by obs not working on 0.37v
only voici SSB working
it's normal?
thank's all

[4Z1ZV]

If I recall, you may need to install modified FW.
Some support both SSB and CW and there are some patches that enable easy control.

Done it years ago on my Pluto based station.

https://www.f5uii.net/en/transmit-datv-over-qo100-with-sdr-adalm-pluto-f5oeo-plutodvb/4/

[magnum88]

Thank's for your reply
but not work for libresdr not pluto blue it's pluto silver in case metal
73
Xavier

[VasylSamoilov]

See here: F5OEO/tezuka_fw#34
and here: F5OEO/tezuka_fw@3e3178f

[4Z1ZV]

Just an update, I was able to stream DATV signal using DATV-Easy 3.08 with a working fw (not modified for DATV).

[magnum88]

Thank's for replay
for me no work with DATV-Red
only work SDRAngel and only USB connection no ETH

[f4exb]

connecting via ETH to SDRangel is done as usual with PlutoSDR and is not entirely straigtforward. Please check the document here: https://github.com/f4exb/sdrangel/blob/master/sdrgui/deviceuserargs.md

Use "PlutoSDR" for the Hardware ID in box (3). Use the "+" button (5) then a line appears in the space below (6) with the "ND" label (Non Discoverable). Click on PlutoSDR line and add in the Args box at the bottom (8) type "uri=ip:192.168.0.40" (whatever the address of the LibreSDR is). Eventually click "OK" to validate and close the dialog. Restart SDRangel to take effect then the PlutoSDR device should appear in the devices list.